EOS 5D Mark IV Body

• CF card

  • Type I drive (Type II and Microdrive non-supported.)

  • UDMA Mode 7 supported.

  • CFast cards cannot be used.

• SD, SDHC and SDXC memory cards

  • UHS-I supported.

  • MultiMediaCards (MMC) cannot be used (results in error).

  • UHS-II not supported. If a UHS-II card is used, it may be slower than a UHS-I (depends on the card specifications).

• Self Cleaning Sensor Unit

  • Removes dust adhering to the low-pass filter.

  • Self-cleaning can be done automatically when the power is turned on/ off.

  • After the cleaning is performed, the camera will automatically restart (Power OFF to ON).

  • When you use Multi Shot Noise Reduction, Clean now cannot be selected.

• Dust Delete Data acquisition and appending

  • The coordinates of the dust adhering to the low-pass filter are detected by a test shot and appended to subsequent images.

  • The dust coordinate data appended to the image is used by the EOS software DPP to automatically erase the dust spots.

• Manual cleaning
   

• Standard

  • Select manually to record on either the CF card or SD card.

• Auto switch card

  • When the current card becomes full, the camera switches to the other card automatically.

• Record separately

  • The CF card and SD card record the same image at a different image recording quality (Large/Fine, Large/Normal, Medium/Fine, Medium/Normal, Small 1/Fine, Small 1/Normal, Small 2, Small 3, RAW, mRAW, sRAW).

• Record to multiple

  • Both the CF card and SD card record the same image at the same image recording quality (Also applies to RAW+JPEG, mRAW+JPEG, and sRAW+JPEG). 

• Continuous numbering

  • The numbering of captured images continues even after you replace the card.

• Auto reset

  • When you replace the card, the numbering will be reset to start from 0001. If the new card already contains images, the numbering will continue from the last recorded image in the card.

• Manual reset

  • Resets the file number to 0001, and creates a new folder automatically. 

• Auto

• Standard

• Portrait

• Landscape

• Fine Detail

• Neutral

• Faithful

• Monochrome

• User Defined 1-3

  1. In Scene Intelligent Auto, [Auto] will be set automatically.

  2. [Standard] is the default setting for [User Def. 1-3].

   

• AF point information

• AF operation*

• Area AF frame

• Metering mode*

• Spot metering circle

• Image quality*

• Electronic level (dedicated indicator)*

• Digital Lens Optimizer*

• Battery (remaining capacity)*

• Dual Pixel RAW setting (shooting)*

• Shooting mode*

• Flicker detection*

• White balance*

• Warning symbol

• Drive mode*

• AF status indicator

You can select whether or not to display the asterisked items [Show/hide in viewfinder].

• Autofocus

  1. One-Shot AF
  2. Predictive AI Servo AF (AI Servo AF III)
  3. AI Focus AF
     • Switches between One-Shot AF and AI Servo AF automatically.

• Manual focus

   

• Single-point Spot AF (Manual selection)

• Single-point AF (Manual selection)

  • The checkmark cannot be removed from this option.

• AF point expansion (Manual selection, 4 points: Up, down, left and right)

• AF point expansion (Manual selection, surrounding 8 points)

• Zone AF (Manual zone selection)

  • All AF points divided into nine focusing zones.

• Large Zone AF (Manual zone selection)

  • All AF points divided into three focusing zones.

• AF point Auto selection AF 

• Enable

• Disable

• IR AF assist beam only

   

• 153,600 effective pixels (480 x 320)

EOS iSA System with 252 zone (18 x 14) metering

• Evaluative metering (linked to all AF points)

• Partial metering (center, approx. 6.1% of viewfinder)

• Spot metering (center, approx. 1.3% of viewfinder)

  • AF point-linked spot metering not provided.

• Center-weighted average metering

• External flash control

  • Flash firing
  • E-TTL II Flash metering
  • Flash sync. speed in Av mode
  • Flash mode
  • Radio transmission wireless flash shooting
  • Optical transmission wireless flash shooting
  • Flash ratio control
  • Zoom
  • Sync setting
  • Flash exposure compensation
  • FEB
  • Clear settings

• Flash Custom Function setting

• Single shooting

• High-speed continuous shooting

• Low-speed continuous shooting

• Silent single shooting

• Silent continuous shooting

• 10-sec. self-timer/remote control

• 2-sec. self-timer/remote control

• With 1/500 sec. or faster shutter speed, maximum aperture (varies depending on the lens), with a fully-charged Battery Pack LP-E6N, and at room temperature (73°F/23°C).

• The maximum continuous shooting speed will decrease under the following shooting conditions:

• [Anti-flicker shoot.: Enable] results in maximum approx. 6.6 fps.

• [Dual Pixel RAW: Enable] and RAW or RAW+JPEG image quality.

• [Digital Lens Optimizer: Enable] will greatly decrease the continuous shooting speed.

• The continuous shooting speed may become slower depending on the shutter speed, aperture, subject conditions, brightness, lens, flash use, temperature, battery type, remaining battery level, etc.

• With the AF mode set to One-Shot AF and the Image Stabilizer turned off when using the following lenses: EF 300mm f/4 L IS USM, EF 28-135mm f/3.5-5.6 IS USM, EF 75-300mm f/4-5.6 IS USM, EF 100-400mm f/4.5-5.6L IS USM.

• In AI Servo AF operation, the continuous shooting speed may become slower depending on the subject and the lens used.

• If you use Battery Pack LP-E6 and shoot in low temperatures (battery temperature is low), the high-speed continuous shooting speed may become slower.

• The continuous shooting speed may become slower if the remaining battery level is low or if you shoot under low-light conditions.

Low-speed continuous shooting: Max. approx. 3.0 fps
Silent continuous shooting: Max. approx. 3.0 fps

• Dual Pixel CMOS AF

  • Dual Pixel CMOS AF is possible with all EF lenses.

• Manual focus

  • Magnify the image by 5x or 10x and focus manually.

   

• Evaluative metering 315-zone (21 x 15)

• Partial metering (approx. 6.3% of Live View screen)

• Spot metering (approx. 2.7% of Live View screen)

• Center-weighted average metering

  • AE lock possible. The active metering timer can be changed.

• 3x3

• 6x4

• 3x3 + diagonals 

• Dual Pixel CMOS AF

• Manual focus

  • Magnify the image by approx. 5x or 10x and focus manually (not possible during movie shooting).

• No information display

• Basic information display

• Detailed shooting information display
  Basic shooting information
  Lens/histogram information
  White balance information
  Picture Style information 1
  Picture Style information 2
  Colour space/noise reduction information
  Lens aberration correction information 1
  Lens aberration correction information 2
  GPS information
  IPTC information (First for EOS)

Index display:

• 4-image index

• 9-image index

• 36-image index

• 100-image index

• Individual images

• Specify images by folder

• Specify all images in card

  • RAW images and movies cannot be specified for printing.

   

• JPEG images

• RAW images

• Movies

   

• Shutter button halfway pressing

• AF-ON button

• AE lock button

• Depth of field preview button

• Lens AF stop button

• Multi-function button

• SET button

• Main Dial

• Quick Control Dial

• Multi controller

• AF area selection button

• Up to six top-tier menu options and Custom Functions can be registered.

• Up to five My Menu tabs can be added.

  • My Menu tab overall operations
    • Adding a tab
    • Deleting tabs in a batch
    • Deleting all tab items
    • Setting the menu display
  • My Menu tab detailed operations
    • Selecting a registered item
    • Sorting registered items
    • Deleting selected registered items
    • Deleting registered items in a batch
    • Deleting tabs
    • Changing a tab name (16 ASCII characters)

• For computer communication

• For WFT-E7 (Ver.2.0) connection

• For Connect Station CS100 connection

• With the AC Adapter + DC Coupler, AC power is possible.

• When the Battery Grip BG-E20 is used, two battery packs (LP-E6N or LP-E6) can be installed.

• Battery level displayed on the LCD panel and in the viewfinder.

• One of six levels displayed for LP-E6N and LP-E6. The display for other power sources is different.

• Even when you set the date, time or zone and 1, 2 or 4 min. is set, it will take 6 min. for auto power off to take effect.

• Recharge time: approx. 8 hr.

  • The recharge time required to provide the above number of months with no battery pack installed.

• Based on CIPA testing standards